All connectors

Power Rating Simulation of the new QNS connector generation

IMS Connector Systems is an international, technology driven company specialized in development and production of high frequency connections. The product range includes a large assortment of coaxial RF connectors, coaxial cable assemblies, RF test switches, RF antenna switches, test adapters and test assemblies, battery contacts as well as antennas for mobile devices. Application and Simulation using CST MICROWAVE STUDIO® and CST EM STUDIO™ by Roland Baur, IMS Connector Systems, Löffingen, Germany Read full article..

3D EM Simulation in the Design Flow of High-Speed Multi-Pin Connectors

This article describes the design flow for a high speed connector using different simulation tools. The goal is to enable a first pass design without time-intensive and costly iteration steps. In addition to other simulation tools, CST MICROWAVE STUDIO® (CST MWS) is used during different stages of the design process to find fundamental design parameters and to predict the behaviour of a complete telecommunication system. Read full article..

Signal integrity analysis and circuit extraction of a mounted SMA connector

A physically based method is used for estimating the equivalent circuit model of an SMA connector soldered on the top plane of a multi-layer board and connected to a single-end stripline. Starting from the scattering parameters (S-parameters) evaluated using a simulation software package, the equivalent circuit is extracted by modeling each part of the structure. The circuit is then validated by comparing the outputs obtained via circuit-level simulation of the extracted physical circuit with those computed by means of the full wave solution. Read full article..

Applications of 3D Electromagnetic Modeling in Magnetic Recording: ESD and Signal Integrity

John Contreras and Al Wallash, Hitachi Global Storage Technologies, presentation at the 5th North American Userforum, 2008. Read full article..

RJ45 Interconnect Signal Integrity

An RJ45 connector model, imported from Pro/E®, is simulated in CST MICROWAVE STUDIO®. The time domain waveforms are compared to TDR measurements. Model and results courtesy of North East Systems Associates (NESA). Read full article..

50 GHz End Launch Connector Test Boards

For many years Southwest Microwave has manufactured field replaceable connectors and launch accessories where connector performance was easily verified by measuring two connectors back-to-back as a two-port device. With the introduction and success of Southwest Microwave end launch connectors, the packaging responsibility has fallen to Southwest Microwave. To assure maximum performance of the Southwest Microwave end launch connectors, equally high performance test boards were needed to accurately measure the connectors. Read full article..