CST – Computer Simulation Technology

CST STUDIO SUITE - Filter Training

This course consists of two full days of hands-on filter design training with CST STUDIO SUITE® and its dedicated tools for the electromagnetic simulation of electronic devices. Filters are one of the most important components in MW/RF industry. With ever-changing industry requirements, their design can be particularly challenging.

This hands-on training will guide you through the complete set of simulation solutions that can be applied in practical filter design, demonstrate the different tools that are applicable in each stage of the design workflow and highlight the underlying technologies that make it possible.

CST Italy Srl office
Viale De Gasperi, 14, Scala G
24047 Treviglio, Italy
9:00 - 17:00 (both days)
From: September 11, 2018
Till: September 12, 2018

Fee:500 €
Registration is open.

This training will cover the following topics

  • Definition of a Bandpass-Filter with Arbitrarily Positioned Symmetric and/or Complex Pairs of Transmission Zeroes
  • Detailed Introduction into CST FilterDesigner3D
  • Synthesis of this Bandpass-Filter using CST FilterDesigner3D
  • Design of a Cavity Type Filter based on the Synthesis Results
  • Parametric Modeling of the Layout
  • Manual Pre-Tuning of Cavities using Various Available Tuning Techniques
  • Explanation of Possible Simulation Solutions
  • Manual Tuning and Automated Optimization based on Coupling Matrix Data
  • VNA Tuning of a Realized Prototype using CST FilterDesigner3D
  • Diplexer Setup and Tuning
  • Multiphysics Analysis for the Designed Bandpass-Filter:
    • Thermal and Mechanical Deformation Simulations
    • Corona and Multipaction Analyses using CST-Spark3d

This training will be held in English.

If you want to discuss your models, please send them to us in advance.

This course is available exclusively to CST customers. Lunch and refreshments will be included. There is a registration deadline one week prior to training and subject to availability. 

Special conditions can be discussed for several participants from the same company, people affiliated with a university, and for companies that have purchased or rented a license recently. For further information, please contact us.


Training equipment

Training material and hardware will be provided on site.

Invoicing

Please note that an invoice will be sent after the training was held.

Cancellation Policy

Cancellations must be made in writing or via your MyCST account. Cancellation of an accepted registration may be made up to seven days before the training without fee. Delegates who request a cancellation after seven days before the training and delegates who do not attend, are responsible for the full attendance fee.

contact support

Your session has expired. Redirecting you to the login page...