CST – Computer Simulation Technology

EMC Simulation of Consumer Electronic Devices

 

All consumer electronic devices need to meet EMC standards. By including EMC compliant design at an early stage, additional costly iterations can be avoided later on down the line. In this eSeminar we will present how board-level EMC design can significantly reduce emissions at their source. We will then focus on system level EMC, discussing different approaches of segmenting the system for an efficient simulation workflow. Finally we will analyze immunity, by demonstrating how different return current path configurations can affect performance of the device due to cable entry susceptibility.

Rate this Video

    Related Videos

  • Automotive PCBs: Efficient Signal and Power Integrity Analysis

    This eSeminar presents efficient workflows for signal integrity (SI) and power integrity analysis (PI) of in-vehicle infotainment systems. CST DESIGN STUDIO™ is used for the pre-layout and CST PCB STUDIO® for the post-layout. Guidelines are given on how...

  • Simulation for EMC Performance in Modern Electronics

    The earlier that potential EMC problems are detected in a design flow, the easier and cheaper it can be to mitigate them. In this eSeminar we will focus on two EMC topics which can be efficiently simulated with the same methods: shielding effectiveness...

  • Power Delivery Network (PDN) Analysis

    This eSeminar will highlight the role of simulation in the design of PCB power delivery network (PDN) systems, demonstrate the decap optimizing tool, and will cover the measurement methodology for the PDN impedance of the power supply plane of the PCB.

  • PCB and Package Co-Design and Co-Optimization

    The drive for higher performance leads to increasing complexity and miniaturization of electronic circuit on-chip, more functionality on package level and high density PCB boards. PCB/Package designers are therefore taking the electrical environment via...

  • High-Speed Serial Link: Full-Wave EM Modeling Methodology and Measurement Correlation

    Different aspects of the challenges in high-speed link modeling will be covered, including chips, packages, PCB’s, connectors and their interactions. Full-wave EM modeling of link will be demonstrated and correlation for both passive and active measurements...

contact support

Your session has expired. Redirecting you to the login page...