This synthesis algorithm will design a linear array for a specified directivity or beamwidth and excitation taper. The direction of peak directivity can be set to any of the Cartesian axis directions. The specification of the excitation taper allows the sidelobes to be controlled. The resulting pattern of this array will always be rotationally symmetric around the chosen axis.
|An example of a 3D pattern for this array.|
The inter element spacing can be used as an input to the design algorithm. Values between 0 λ and 5 λ are possible. If a spacing of over 0.5 λ is used, unwanted grating lobes will be present together with the desired main lobe. When this occurs, the peak directivity could be lower than designed for. The energy in the grating lobe should be compensated for in the design requirements of the main lobe. The excitation taper can be selected between equal excitation [Uniform], uniform side lobe level [Dolph-Chebychev] and first few side lobes uniform [Villeneuve]. The side lobe level and number of side lobes (where applicable) can then be set....
More information about how the array synthesis tool should be used can be found in ‘Antenna Array Synthesis in Antenna Magus’ and in ‘Help: How do I use the Array Synthesis tool?’ (located in the Antenna Magus information browser). The latter article also describes the different excitation tapers in more detail, and provides references for further research.