RFID and Wireless Power Transfer Simulation from Tag to System
This article discusses the design and modeling of both low frequency (LF) and high
frequency (HF) RFID devices using CST STUDIO SUITE®. This can be done at the level of
the individual tag, but also for the entire system, including the reader, the tagged object
and its surroundings. Analyzing the entire system with simulation allows the suitability of
the chosen RFID system for the application to be investigated, and can reveal unforeseen
interactions that can be hard to identify with measurement alone.
You need to be signed into MyCST to access the full article. Don’t have an account? Register here.Full Article
Power Rating Simulation of the new QNS Connector Generation
IMS Connector Systems used CST EM STUDIO® to simulate a QNS connector and thus determine its power rating. The comparison between measurement and simulation shows a very low deviation, showing that the EM-Thermal Co-Simulation is a very helpful tool to...
RFID Reader-Coil, 13.56 MHz
Radio Frequency Identification Systems (RFID) are widely used and allow advanced solutions for a variety of applications in the area of authentication, ticketing, access control, supply management, parking, payment, vending,etc. The example presented...
A Unit Cell Model of a Single Periodic Waveguide Phased-Array Antenna
A single periodic open-ended waveguide phased-array antenna is analysed with a dielectric radome of variable thickness at its aperture. As a verification it is shown that the superposition of two independent plane waves shows the same field pattern as...
GSM/DCS Dual Antenna Switch Module (ASM)
This structure for mobile communication in LTCC technology combines a diplexer for the GSM and DCS frequency bands with a low pass filter for each band.
RFID Transponder Operating at 13.56 MHz
Radio Frequency Identification Systems (RFID) are widely used and are thus an important sector in today's radio industry, allowing advanced solutions for a variety of applications in the area of authentication, ticketing, access control, supply management,...
Your session has expired. Redirecting you to the login page...
When you browse our website, cookies are enabled by default and data may be read or stored locally on your device. You can set your preferences below:
These cookies enable additional functionality like saving preferences, allowing social interactions and analyzing usage for site optimization.
These cookies enable us and third parties to serve ads that are relevant to your interests.