CST – Computer Simulation Technology

Signal Integrity Analysis and Circuit Extraction of a Mounted SMA Connector

September 2008

Signal Integrity Analysis and Circuit Extraction of a Mounted SMA Connector
A physically based method is used for estimating the equivalent circuit model of an SMA connector soldered on the top plane of a multi-layer board and connected to a single-end stripline. Starting from the scattering parameters (S-parameters) evaluated using a simulation software package, the equivalent circuit is extracted by modeling each part of the structure. The circuit is then validated by comparing the outputs obtained via circuit-level simulation of the extracted physical circuit with those computed by means of the full wave solution.
contact support

Your session has expired. Redirecting you to the login page...